Dynamometer Results & Comparisons Dyno Records | Dyno Discussion | Dyno Wars

Stock LS1 Results?

Thread Tools
 
Search this Thread
 
Old 07-06-2011, 10:24 PM
  #1  
Staging Lane
Thread Starter
iTrader: (19)
 
93LS1S10's Avatar
 
Join Date: Jun 2011
Location: Felton, DE
Posts: 91
Likes: 0
Received 0 Likes on 0 Posts

Default Stock LS1 Results?

I have a 93 S10 that i swapped a LS1/T56 combo into from an 02 trans am. It is factory other than a home made CAI, shorty headers, an SLP dual exhaust, and a tune by Race Proven Motersports. It dynoed at 325 hp and 340 tq. Is this Good?
Old 07-06-2011, 10:27 PM
  #2  
12 Second Club
iTrader: (8)
 
lynx853's Avatar
 
Join Date: Jun 2006
Location: NC
Posts: 191
Received 4 Likes on 2 Posts

Default

yup! good job, strong motor!
Old 07-07-2011, 07:01 AM
  #3  
Staging Lane
Thread Starter
iTrader: (19)
 
93LS1S10's Avatar
 
Join Date: Jun 2011
Location: Felton, DE
Posts: 91
Likes: 0
Received 0 Likes on 0 Posts

Default

Ok, thanks. Just wanted to make sure it was where it should be.
Old 07-09-2011, 01:43 PM
  #4  
Staging Lane
 
Tongboy's Avatar
 
Join Date: Dec 2005
Location: Portland, Oregon
Posts: 86
Likes: 0
Received 0 Likes on 0 Posts
Default

it's best to compare with people with similar rear-ends to your setup for the best accuracy but you're right in line with where you would expect after a tune.

for comparison in a swap car I put down 307/323 with just longtubes and a home made hot air intake (make sure your IATs are appropriate with your CAI or you're leaving power on the table) and the cars stock exhaust, redoing the exhaust bumped me up to 317/332
Old 07-22-2011, 10:26 PM
  #5  
TECH Enthusiast
iTrader: (4)
 
Isolde's Avatar
 
Join Date: Mar 2009
Location: Smithfield, UT
Posts: 648
Likes: 0
Received 1 Like on 1 Post
Default

Originally Posted by Tongboy
it's best to compare with people with similar rear-ends to your setup for the best accuracy but you're right in line with where you would expect after a tune.

for comparison in a swap car I put down 307/323 with just longtubes and a home made hot air intake (make sure your IATs are appropriate with your CAI or you're leaving power on the table) and the cars stock exhaust, redoing the exhaust bumped me up to 317/332
Different brackets, but same basic rear axle. GM 7.625" 10-bolt. All '85-up S-10 except ZR2, all '93-'02 F-cars.




All times are GMT -5. The time now is 11:16 PM.