my bandit

iTrader: (10)

i just installed flowtech headers (used) but when i was looking at the ypipe i noticed that where the driver side pipe is connected to the passenger side, it just looks like someone took a hole saw to the PS pipe and just welded it on. i dont even think it is the right sized hole. i dont think this would cause much of a problem but its a 3" pipe. im deciding if i want to take it to a shop and pay 100 bucks to get this one little thing fixed.

99peweterls1

iTrader: (1)

Hmm.. my flowtech is fine, maybe take some pics so we can see.

my bandit

iTrader: (10)

i didnt get any. i tried but they didnt come out good. hole just wasnt the same size size as the pipe going in but i just didnt want it to cause any problems

99peweterls1

iTrader: (1)

if its as bad as you say it is just get it fixed right. It will be in the back of your mun if you dont. Get a good merge pipe.

BlackScreaminMachine

iTrader: (17)

Used is used, unfortunately probably better off buying new if you had to spend cash to fix stuff.

omarrakeen

iTrader: (2)

i saw their Y pipe. but i went custom due to the price..it costs 250$ around here, i went custom. its a nice piece minus the merge. just order a flowmaster merge and weld it in there. how does it fit?

99peweterls1

iTrader: (1)

^^ this or a mufflex

my bandit

iTrader: (10)

my guess is the hole is a 2-2.5" hole.... the fitment of the headers was perfect. the ypipe was about an inch off (it was alittle bent) so i had to get that fixed. i just dont want to spend the unnecessary 100 bucks for labor just to get this tiny problem fixed if its not serious. i mean i only paid 180 bucks for the headers, ORY, o2 extensions, gm gaskets and jegster subframe connectors...

99peweterls1

iTrader: (1)

Its hard to give you good advise other than what was already said without seeing your problem.