MP112 height difference?
08-20-2011, 07:29 PM
#1
11 Second Club
Thread Starter
iTrader: (7)
Join Date: Dec 2007
Location: South Shore, NS
Posts: 216
Likes: 0
Received 0 Likes
on
0 Posts
MP112 height difference? I know this is a long shot since few members seem to run this "small" blower but I'm needing to know the height difference vs say a FAST 90 intake or even an LS6 intake so I can measure to know if it will fit under my hood of my Datsun.
I have only seen one picture which gives me a reference and I'm guessing at around 2" taller but guessing doesn't help since I will not cut my Datsun's hood to make it fit.
If anyone can give educated advice I'd be greatly appreciative.
Thank you
I have only seen one picture which gives me a reference and I'm guessing at around 2" taller but guessing doesn't help since I will not cut my Datsun's hood to make it fit.
If anyone can give educated advice I'd be greatly appreciative.
Thank you
08-20-2011, 07:43 PM
#2
If you can't find the answer on the board, you can call Magnuson and they will be able to tell you. That looks like the same setup (MP112, intake manifold, jackshaft, idlers, etc) that they sell for their "hotrod" kit, which is a stripped-down universal kit. I am sure they could give you the height of the assembly, probably from the valley cover.
BTW, I have one of those "small" blowers for sale! (see link below)
BTW, I have one of those "small" blowers for sale! (see link below)
