Western Members - A big thanks to CMS

Some small things needed to be fixed on my tune and Ryne got it done for me. Car runs great now, I just need to do a rebuild on the rear end. Thank you Ryne.

yo Adam, are you guys going to irwindale this coming thursday?

I believe so, my fiance is bugging me and asking if we are going since she misses it too lol

I believe so, my fiance is bugging me and asking if we are going since she misses it too lol

haha cool, i wanna go and check it out.

Alright well I will PM ya my number hit me up if you go, typically we go then hit up BJ's brewhouse afterwards since there is one like 2 miles north west of the track.

Nice Adam, now it's time for a sick ass 454 lsx 106mm turbo setup?

Hey Adam, hit me up when you finally get the tools to replace the bearings.

Good choice on CMS. I only trust them with my Hailey. Just got her back 3 weeks ago with a Procharger and other work.

Good choice on CMS. I only trust them with my Hailey. Just got her back 3 weeks ago with a Procharger and other work.

I only trust Ryne with tuning my car, I have had nothing but great service from him and sometimes little Mikey lol. I still do my own work on other things but he knows what he is doing with these tunes.

Hey Adam, hit me up when you finally get the tools to replace the bearings.

I am thinking of making my own axle bearing removal tool, I will share once I get to it.


Ivan that would be nice but I am not made of money lol, I would love to have that setup haha.

I am thinking of making my own axle bearing removal tool, I will share once I get to it.


Ivan that would be nice but I am not made of money lol, I would love to have that setup haha.

You can rent those from autozone for free. I used their bearing puller when I built a 8.8 for my SVO and worked like a charm. I have a race driver if your going to replace the pinion bearings. and I have a dial-type inch lbs torque wrench to set the pinion bearing preload.

You can rent those from autozone for free. I used their bearing puller when I built a 8.8 for my SVO and worked like a charm. I have a race driver if your going to replace the pinion bearings. and I have a dial-type inch lbs torque wrench to set the pinion bearing preload.

I was going to get a ling piece of steel bar stalk from home depot long enough to come from the other side of the axle you are working on and making a screw in piece that is small enough to fit in the axle tube and large enough to press against the bearing to hammer the sucker out lol.

I will draw a picture if needed but I see it in my head lol.

Great work at CMS. Congrats on your experience.

I can't wait to have my lt1 24x tuned by cms; the motor runs a lot better now even with just a blind base tune from Ryne.