Help w balancer
09-29-2011, 02:40 AM
#1
Staging Lane
Thread Starter
Join Date: Oct 2006
Posts: 90
Likes: 0
Received 0 Likes
on
0 Posts
Help w balancer Ok, i was going to swap cams, and after i got the bolt out, i was using a 3prong pulley pulling device and it snapped one of the ears off the pulley where the pulley puller arms go. Now what to do, a hammer wont fit to beat it off? Help please.
09-29-2011, 09:21 AM
#2
TECH Apprentice
iTrader: (18)
Join Date: Mar 2010
Location: Austin, Tx
Posts: 366
Likes: 0
Received 0 Likes
on
0 Posts
That sounds shitty. There aren't really ears, though. there are notches in the back of the inner part that the puller goes onto. Feel behind the inner part between the "spokes" and find the notches I'm talking about. Can you post a picture of what broke.
I bet heating the pulley up would help it come off easier but those things are pressed on with some force.
I bet heating the pulley up would help it come off easier but those things are pressed on with some force.
