Does anyone make a ls1 plate with lines that connect on pass side?
#1
11 Second Club
Thread Starter
iTrader: (10)
Join Date: Aug 2003
Location: Bel Air, MD
Posts: 932
Likes: 0
Received 0 Likes
on
0 Posts
Does anyone make a ls1 plate with lines that connect on pass side?
Simple question. Have a nozzle now and it'd be easier to have the 3an lines connect on pass side instead of one on each side, both on drivers, both on rear....
im thinking no....
im thinking no....
#7
Guest
Posts: n/a
It's very hard to put both the fittings on one single side with the 78, 90, and 92mm plates but it can be done. We are still doing it but we make the customer aware that it is difficult and if we end up scrapping the plate somehow they would have to buy a new one. The tollerences are extremely tight.
You can rotate our plates but I really wouldn't suggest flipping it over...
You can rotate our plates but I really wouldn't suggest flipping it over...