Master cylinder removal????
#1
Launching!
Thread Starter
iTrader: (2)
Join Date: Nov 2008
Location: fort smith, ar
Posts: 233
Likes: 0
Received 0 Likes
on
0 Posts
Master cylinder removal????
Trying to swap out master cylinders but cant figure out the steel braided line??? Mine doesnt look like this,
https://ls1tech.com/forums/manual-tr...der-video.html
It doesnt have the quick disconnect.
https://ls1tech.com/forums/manual-tr...der-video.html
It doesnt have the quick disconnect.
#2
Launching!
Thread Starter
iTrader: (2)
Join Date: Nov 2008
Location: fort smith, ar
Posts: 233
Likes: 0
Received 0 Likes
on
0 Posts
I just popped the old mastercylinder out and pulled it to the ground and popped the roll pin out and swapped the new one on like that instead of pulling the line out of the trans. Now the line where the roll pin goes in is leaking. Any ideas????