pwrtrip75

iTrader: (8)

This boost controller I got, the gauge end, display, programming.. all work fine. Ive hooked it up both the different ways that the instructions say... single turbo to external wastegate... la la la. The thing does nothing.
Stays at gate pressure no matter what I do.

Is there a way to test the solenoid? I have no way of knowing if it works. Cant really hang my head under the hood while making boost.

js2fst

iTrader: (12)

Call Marty at Turbosmart

pwrtrip75

iTrader: (8)

Its probably too late right now.. and tomorrow is sunday

MUSTANGBRKR02

iTrader: (91)

You do know that the reading that you set is not psi but a percent of the spring. So setting it to lets say 12 isn't 12psi.

pwrtrip75

iTrader: (8)

Yes, I know this. I have it set up for 3 settings, low, mid, high.. it stays right at my spring pressure of 6psi.

tomz28

iTrader: (20)

what is GP set at? tell me what you have tired

MUSTANGBRKR02

iTrader: (91)

It's so hard to troubleshoot this thing without looking at it.

pwrtrip75

iTrader: (8)

I will go out tomorrow and look.

stevieturbo

Ensure the overboost obS trip is set high enough that you can actually make boost before it shuts down to protect.

tomz28

iTrader: (20)

^^^^^^^thats a good point to. it is really hard to help without looking at it lol

VUSS383

Agree exact setting are need to help out ! Also have a look & report back with the pressure displayed @ key on & also at idle !

skinnies

iTrader: (33)

I'd think that noid should be just power/ground, you can test it to make sure it cycles at least. I've never used the eboost2, but should be the same as other noids out there.

10sec_rx7

the soloniod will click when you first power it up,