Gen III Electronic Pedal on a Gen IV?
12-10-2011, 05:35 PM
#1
Staging Lane
Thread Starter
Gen III Electronic Pedal on a Gen IV? Hello,
Is there a way to adapt and connect a Gen III Electronic pedal onto a GenIV?
By looking at the schematics they both have two potentiomenters, what I do not know is the values and resistances of these.
Can they be spliced together or tweaked with some sort of resistors?
Yes, I know that it is just "easier" to grab the right pedal, but where I am at I just can not find any, and the Ebay articles are a good week and a half away from me.
Is there a Drive by Cable program for the Gen IV E38 ECM?
Thanks
Rat Chevelle
Is there a way to adapt and connect a Gen III Electronic pedal onto a GenIV?
By looking at the schematics they both have two potentiomenters, what I do not know is the values and resistances of these.
Can they be spliced together or tweaked with some sort of resistors?
Yes, I know that it is just "easier" to grab the right pedal, but where I am at I just can not find any, and the Ebay articles are a good week and a half away from me.
Is there a Drive by Cable program for the Gen IV E38 ECM?
Thanks
Rat Chevelle
