TUCKZ28SS

iTrader: (2)

I know some of you have done this before, did you shave off the factory pegs on the back of the emblem or did you drill your fender? I would rather not drill obviously. haha I have a roll of double sided 3m emblem tape. any help is appreciated, pics always help too! Thanks!

Arctic_Z

I used a dremel to take off the pegs. Since the ones I bought at an arch to them, I gently flattened them so they'd fit better. Also used 3m tape.

ssteven

iTrader: (6)

I shaved off the rear pegs and flattened out the badge also. Spent 20 min each side just adding the 3m tape on the back.

http://i280.photobucket.com/albums/k...Picture123.jpg

TUCKZ28SS

iTrader: (2)

how did you flatten them

Arctic_Z

I put a leather glove over the badge and hit it gently with a rubber mallet, did the trick

TUCKZ28SS

iTrader: (2)

thanks Fellas!!

transam5.7lt1

iTrader: (18)

PERFECT_Z28 has a very nice car with those badges.

shaun

i been wondering about this also.
i have the 69 z28 badge on my billet grill and want em for my fenders.
for the time being i just got the stickers from fourthcircledesigns.com.