poopman

iTrader: (48)

I am thinking about buying a d1sc procharger for my car. I was wondering how fast people are running with their pro charger setup's in the quarter mile. My car will be a bolton only ls1 6 speed for now. Just trying to gpet some ideas on how fast my car would go. It has a s60 and viper spec 6 speed. So it is ready for some power to be thrown at it. And i want to know how much power they are putting down. Thanks

alexcoreas

iTrader: (1)

This is a great thread for people like me, maybe you should list specifics. Weight, car, gear, clutch to get a better more accurate list. People running all kinds of E.T

I hope people participate .

poopman

iTrader: (48)

Me too

silver_82

got a buddy with a d1sc in a street strip trans am. Has been 9.84 and 141mph with it, I think on 13lbs.

He uses a th400, but when he had a 6 speed it put down 790hp on pumpgas, this was with the airfilter off, with the elbow and filter on it put down 715hp

poopman

iTrader: (48)

What else is done to it?

JUSTINSWS6

That is some crazy hp through a auto thats awsome! Thos is a great thread. Should maybe become a sticky...

silver_82

It ran high 9s with a good torque arm and rear lcas, all other susp was stock. m9, th400 with brake. good rods and pistons, dart heads, fast 90/90, headers, bolt on stuff mostly. stock pcm, good tune.

silver_82

Those numbers were though the 6 speed as I stated, he hasnt dyno'd it with the auto

JUSTINSWS6

Ok i read that know. That is still very impressive. What heads, cam, intake did he have?

Hi-Po

iTrader: (4)

I would like to see some detailed times as well.

I have a AES 398", Mast LS3 12* heads, F1A project starting soon. I'm hoping the Mast LS3 heads shine with the F1A.

jjcamaro02

iTrader: (34)

I have run 9.58 @ 142 with 1.31 60 ft. This was with a 3.4 pulley maxing out my D1sc, not sure on the rwhp.
Car race weight is around 3750 lbs. Other mods in my sig.

Hi-Po

iTrader: (4)

Damn! That's right where I want to be after the auto swap. Great times and MPH.

JUSTINSWS6

Thats haulin some a$$! nice car with some nice numbers.

'Trust'

iTrader: (24)

Back when I had the TA I went 9.9s at 130 MPH (blowing through the converter), 1.3 60' on the footbrake, 4L60E car, 3966lbs. On the good converter it made 808rwhp, but never got it back to the track.

blue00ZZleeper

iTrader: (5)

If you read the fastest time's list you can find a couple of them. There is also a big "Procharger Guys" thread which has a lot of info posted in it. Do a search....you'll come up with a decent amount of info. I know KP has been high 8's with a F1A, low low 9's with a D1SC, As Trust said he's gone pretty fast without even fully sorting his car out (would go quite a bit quicker) Deshmittie has gone into the 9's on his combo, Bob at EPP has some good times with his procharged car. Helicoil and his old combo have gone fast as hell lol. Do a search...you come up with a lot. I only have dyno info for now until I get to run here lol

9sectruck

iTrader: (9)

mines in my sig
my girls heavy

Packy

iTrader: (11)

I make 550rwhp with around 520 lb ft torque and run 10.20's to 10.30's with my p1sc.

BOBS99SS

iTrader: (2)

my buddy was well into the 10s with a pro charger d1sc,auto,ls6 cam, and a few other parts

Bob@BruteSpeed

iTrader: (16)

http://www.youtube.com/watch?v=xB7YF..._order&list=UL

http://www.youtube.com/watch?v=NTS4T...f=mfu_in_order

Here's a couple videos of my old '99 Z28 with an F-1A. Bob

dschmittie1

iTrader: (64)

When mine was a forged 347 stock 241 heads and ls6 intake t56 car with a D1 it put down 676rwhp on 13psi and went a 10.3@138mph. Put a TH400 in the car and changed heads and cam and went 9.8@142mph. Never got a good pass with the TH400 and D1 before I had a major failure with my D1 and then switched to turbo