FS: New 799 heads
#1
On The Tree
Thread Starter
iTrader: (100)
Join Date: May 2005
Location: Menasha, WI
Posts: 175
Likes: 0
Received 0 Likes
on
0 Posts
FS: New 799 heads
Category: Engine - Intake/Fuel
Price: $450
Location (State): WI
Item Condition: Brand New
Shipping Information: Item Can be Shipped
Engine: LS1/LS6
LS Engine?: Fits LS Engine
I bought these brand new "take off" 799 heads for my 04 GTO and don't need them since I ended up buying ported heads.
These have stock valves, springs etc, but were milled to 59cc.
SOLD
Last edited by hifi dream; 01-29-2012 at 07:35 PM.
Trending Topics
#13
On The Tree
iTrader: (1)
Join Date: Dec 2010
Location: Ft. Worth
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
I received these heads on Wednesday, fast shipping! Packaging was first rate.
Checked them out on Thursday. Found they had been milled improperly. They were not 59 CCs. CCd 1 head and found chambers from 60.8-62.3 CC. A dial caliper revealed both heads were approx .010 thicker front to back....
Yesterday I took them to my machine shop who also verified this.
PMd the seller Marc late last night with my findings, machine shop contact information, and 3 possible "solutions" for this. Paypal refund of milling costs, pay the machine shop directly, or shipment back to Marc for full refund.
Figured I was going to get scammed once again. I have had more than my fair share of bad deals in the past.....
Received PM from Marc this morning stating refund for milling costs had been sent to me!!!!!
Great seller! I expected serious trouble with this and Marc stood behind his parts as I would have!!! I wish there was a section for positive trader posts!
Thanks again Marc!
Any thread you start that I see I will post favorable comments in. Buying from you was a refreshing experience and helps to increase confidence in buying stuff off this forum.
I wish ALL people had your ethics; the world would be a better place....
Cheers
Rick
Checked them out on Thursday. Found they had been milled improperly. They were not 59 CCs. CCd 1 head and found chambers from 60.8-62.3 CC. A dial caliper revealed both heads were approx .010 thicker front to back....
Yesterday I took them to my machine shop who also verified this.
PMd the seller Marc late last night with my findings, machine shop contact information, and 3 possible "solutions" for this. Paypal refund of milling costs, pay the machine shop directly, or shipment back to Marc for full refund.
Figured I was going to get scammed once again. I have had more than my fair share of bad deals in the past.....
Received PM from Marc this morning stating refund for milling costs had been sent to me!!!!!
Great seller! I expected serious trouble with this and Marc stood behind his parts as I would have!!! I wish there was a section for positive trader posts!
Thanks again Marc!
Any thread you start that I see I will post favorable comments in. Buying from you was a refreshing experience and helps to increase confidence in buying stuff off this forum.
I wish ALL people had your ethics; the world would be a better place....
Cheers
Rick