Jake_the_Snake

iTrader: (5)

this one's getting up there in miles so i'm trying to get a quote so i know where to go for when the inevitable happens. might take it in before it pops so i don't get caught off guard. i would do it myself, but i have no garage to work in

kingd_202

iTrader: (7)

You might wanna try Mark Shaner (not sure if he does LT1) he quoted me money for a complete overhaul on my ls1..

mitchntx

iTrader: (14)

Mark Shaner is still around? I remember him turning TBs in his front room of his house in Arlington ... damn that was a long time ago.

I had my LT1 rebuilt by Wayne Calvert in Denton.

SnIpEz

iTrader: (4)

Ha, was just up at Calvert's yesterday.

Jake_the_Snake

iTrader: (5)

were you satisfied with his work? any chance you could tell me what exactly he did and how much he charged? trying to figure out if i should get this one rebuilt, swap an ls1, or just get a new car lol

94fixerTA

iTrader: (5)

Wayne has been doing motors for longer than almost everyone on here has been alive. He did my 383 and made great recommendations for valve work and internals. He won't beat around the bush about stuff either. Idk if he will pull your motor though. The shop right next to him may do that but I did mine myself.

Glenn98ZM6

Richard Painter did my CMC road race car motor for well under $2K a couple years back. Been running like a top ever since. He is off 183 in Euless.

LowestIntentions

That is right down the road for me. What did you have him build for you for that great price? Was that price for just machine work or parts and assembly as well?

Glenn98ZM6

It was an OEM build for my CMC 4th gen. Parts, machine work and assembly.

ProTreeRacing

iTrader: (4)

This post is old, but we do rebuilt LT1's and work on them as much as we do LS stuff.

LowestIntentions

That is good to know. I will look y'all up and contact this week. I am currently trying to decide on 355 or 383. It is all going to depend on what I can figure out for machining costs this week.