Angelle racing

went to the track sat and my car went 11.95@119 with a 1.69 60ft

Youshallgofo

iTrader: (1)

mods? DA? Car?

Angelle racing

I have F13 cam ,3600 yank conv and bolt on's with NT05R drag radials and its a 1998 camaro z28

Killer5.3

iTrader: (1)

Really good mph , but , you should have been closer to 11.50 or so with that 1.69 short time. Do you have the slip that shows your incrementals and what was your 1/8 numbers?

thunderstruck507

iTrader: (18)

Those numbers seem off.

I ran 11.92@111mph with a 1.69 60ft. If you really trapped 119mph with that 60ft the car should have been much faster I would think.

Angelle racing

Thats what the slip said

SweeTbone

iTrader: (8)

Flying MPH for an auto. I did 12.1 @ 119 with a 2.0 second 60' in my M6. What kind of suspension mods? I'm not too familiar if autos with stock suspension cut good 60' times or not.

Angelle racing

it has stock suspension

twizted_creations

iTrader: (4)

On a dead hook with stock suspension, 3.23s and a 4k stall sitting on 28" mickeys I cut a 1.71 60" but that was bogging... Geared up last year, and added a few extra ponies a better tune and some drag shocks, so we shall see if the 10 bolt will hold up for another track pass or 2. I am expecting a 1.5x short time this time around, if I can keep her planted and not go boom.

Autos will put down good short times if you have enough of a converter in them and launch it properly.

Mac 2002 SS

iTrader: (6)

Congrats !! Now put a set of Stg II LS6 Heads, ET Streets DR's , lil' bit of suspesion work and the F13 cam will really shine for you . I love mine !

SAPS

Close to what I ran...my mph was a bit low due to bad tune and hitting rev limiter the whole way down the 1320.

My 60ft was 1.9

With DR's, I think I could get down to the 11.40 to 11.50 range.