T/A KID

iTrader: (12)

Category: Engine - Intake/Fuel
Price: $1450
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette
Location (State): AR
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LT1/LT4
LS Engine?: Non-LS Part

Selling my AFR 216 runner LT1 LT4 heads off my procharged project. These heads started out at 195 AFR heads, and have been ported by Lloyd Elliot (portworks.com) out of Texas and the runner length is 216 now. I can get flow numbers for these heads, but they peaked at 294cfm at .600 and 236 exhaust (with pipe) using 2.05 intake 1.60 exhaust valve, 57cc. I have around $2600 in this setup and I am pricing to sell quick.

These heads have abour 100 miles on them and 6-8 dyno pulls on my engine.
ONLY reason I am selling it going with a different engine setup. These heads are ready to bolt up and go.

Asking 1450 Shipped to your door, these gotta go, so price is cheap.

Serious offers only

Thanks Ben
Here was the engine

T/A KID

iTrader: (12)

found out I will need a different exhaust valve, so the buyer will receive these heads bare, BUT with valvs, just add your head hardware like valvesprings, rockers studs, rocker arms (use of your existing heads if you want to go that route, this is what I mean by hardware)

These same heads from AFR bare that flow 30 CFM less on the intake/exhaust will cost around 2000

I don't care to lose a little since I want to mess with a new project
Here is the flow numbers from Lloyd Elliot

The intake has a 58/45/33 valve job and the exhaust is a radius type valve job.

.2 136/105

.3 191/139

.4 241/173

.5 271/198

.6 289/214

.650 294/219

These were on Lloyds conservative bench, exhaust flow is without a pipe, he mentioned they would be around 236 with pipe