streetknight2

iTrader: (10)

I have dynatech headers. Should I run a X pipe? Want to dump in front of rear end. Also, what mufflers are you guys using.

Rpayne41985

iTrader: (12)

I run a universal xpipe from jegs and bullets

1bad03snake

iTrader: (16)

That's what I plan on doing.

johnyrrr

iTrader: (2)

I have the AJE K-member/trans x member and the Dynatechs as well and the drivers side header dumps right infront of the trans support. I am sure I will have to trim the drivers side header back a little. Would like to see what others are doing as well. Id like to run the stock like tail pipes though too if possible. Can we see some underbody pics??

SN-95

I had to trim about an inch off of my dynatechs. I've got dual 3" with an x-pipe and bullets

1bad03snake

iTrader: (16)

I'm going to buy all the tubing and take it to a muffler shop to have them flange everything and tuck it under the car.

Gray86hatch

iTrader: (83)

I used a Jegs X and trimed the collectors back.

It dosn't take much to make it fit on these cars

Tim

streetknight2

iTrader: (10)

Where does the X end up in relation to the transmission

Gray86hatch

iTrader: (83)

Just behind the crossmember.

johnyrrr

iTrader: (2)

Well cmon, lets see some pics...What kind of conector did you use to connect the X-pipe to the headers?

1bad03snake

iTrader: (16)

Anyone have any pics? What Jegs kit did you use?