Generation IV Internal Engine - Can somebody give me the measurements of the intake port of an ls7 head?

I have a sheemetal intake that has a port that was designed for a c5r head and i am trying to see if somebody could measure an ls7 head and give me the measurements so I can see how close it is to this intake. I know they are close but I need an exact measurement. Also, is there anything besides the port size that there is a difference between the 2? This is going on a boosted setup and I would really like to use this intake. Here is a pic of the intake.

http://i51.photobucket.com/albums/f396/87silverbullet/imagejpeg_2_11-1.jpg
http://i51.photobucket.com/albums/f396/87silverbullet/imagejpeg_4_3.jpg

C'mon I know somebody has an ls7 head laying around they can measure? Or at least sell me a broken head so i can mock it up

There were a couple of fragged LS7 heads on E-Bay a few weeks back...

Thanks man. Im going to see if i can find them

I've got an LS7 head sitting on the workbench, here is what the intake port measured:

1.376" Wide
2.380" Tall

Hope that helps!

I've got an LS7 head sitting on the workbench, here is what the intake port measured:

1.376" Wide
2.380" Tall

Hope that helps!

Thanks man you're a lifesaver!

Do you need that head because I would still like to mock up bolt holes and not guess?

No problem!

Yeah sorry, I need it...let me know if you need any more measurements though.

I'm 98% sure the port location is different between the two.

I hope not.

I did some research and there were a few people that were doing the opposite of me and trying to put an LS7 intake on c5r heads. Just the bolt holes were off.

http://m.modernhemi.com/forums/showthread.php?t=1132234