Pontiac G8 2008-2010 - Strut bushings and LCA's

Planning on using BMR poly Strut bushings, but what about LCA's? I seen Spohn's aluminum LCA's with the rebuildable delrin balljoints. Anybody used these and what is your opinion of them?

I also looked at Pedders, but leaning towards the Spohn's b/c of the cost and the ability to rebuild the balljoints.

What has anyone had good luck with?

What are your experiences with the newer updated OE LCA's?

Id go for spohns lcas and opt for the ferlin bushing is a must

Can anyone here verify which 'strut bushing' I need- both these KYB and Moog look very different unless one is just a generic photo. I would assume the Moog one

http://www.partstrain.com/store/?N=0&Nr=AND%28universal%3A0%29&PN=0+4294942356&VN=4294967112+4294959936+4294959767+4294967043+429 4966097&domain=partstrain.com&Nr=AND%28universal:0%29

The Moog piece is the "Strut Bushing". I would get poly though. If you are interested in poly bushings, let me know and I can direct you to a much cheaper alternative.

I got my poly strut bushings and bearings for $158 shipped.