TrplBlk

I know everyone is saying to measure to make sure my PTV clearance is good. I just want to know if I should have a friend send me the 7.4's I bought from him, or have him save them and measure BEFORE I get the rods and just buy new ones?

I know every engine is different so any help is appreciated!

09camaro383

iTrader: (2)

buy the pushrod length checker its easy to use it will tell you what length you need instead of guessing around

http://www.jegs.com/i/Comp+Cams/249/7702-1/10002/-1

99RedrocketSS

Measure first and it will save a lot of headache.

badazz81z28

iTrader: (6)

Are the #799s milled +.020 , +.030? If they are, you will have issues.

TrplBlk

The place where I work has a pushrod checker so I can do that, but mainly was wondering if I should have him keep his push rods till I know what size I need?

And the heads are not milled. They're stock.