Fuel Filter Selection Help
04-03-2012, 12:03 PM
#1
TECH Apprentice
Thread Starter
iTrader: (1)
Join Date: Jun 2005
Location: North Alabama
Posts: 327
Likes: 0
Received 0 Likes
on
0 Posts
Fuel Filter Selection Help I am trying to set up the fuel system on my brother rock buggy with a LQ4 in it. The regulator is on the rail and since the filter is going to be seen I would like to use a good looking in-line like shown below. I was going to place it after the pump, but what micron should I get? Also since the buggy will often be in a nasty environment I was thinking about also putting one pre pump just incase dirt gets in the fuel cell. What micron would I need there? Thanks for any help.
http://www.summitracing.com/parts/RUS-650103/
Chase
http://www.summitracing.com/parts/RUS-650103/
Chase
04-03-2012, 12:41 PM
#3
The one you link will work for a prepump filter. They are typically 40 or 100 micron depending on the type of pump. I have the Summit store brand equivalent of that. there is just a small screen inside that big *** cavity.
After pump filter should be 10 micron. They typically have some type of paper filter element.
After pump filter should be 10 micron. They typically have some type of paper filter element.
04-03-2012, 08:02 PM
#4
TECH Apprentice
Thread Starter
iTrader: (1)
Join Date: Jun 2005
Location: North Alabama
Posts: 327
Likes: 0
Received 0 Likes
on
0 Posts
The one you link will work for a prepump filter. They are typically 40 or 100 micron depending on the type of pump. I have the Summit store brand equivalent of that. there is just a small screen inside that big *** cavity.
After pump filter should be 10 micron. They typically have some type of paper filter element.
After pump filter should be 10 micron. They typically have some type of paper filter element.
