General LSX Automobile Discussion - Fitting a hatch in a Camaro?

Hey guys. Looking for a little imput. I'm gonna be helping my friend out by picking up a hatch for him. My question is, is if I can fit the hatch ( at an angle) into the camaro. I dont really need my hatch to close. Rope can be used to keep it shut. Any tips or opinions are much appreciated...

Seriously doubtable and I've fit mattresses inside my car. When I got the hatch i had to fit it diagonally into a panel van.

But Rob, is the hatch gonna fit diagonally in the opening?

Funny that you two are the ones in this thread discussing this.

Im tryin for ya Mike. Lol. We'll make it work

Idk man, cause if you think about it the hatch is the outside width of the car so u
d have to fit that on the inside width. If mike doesn't mind waiting till may 12ish i can bring it up for him.

Rob, no worries man. That should be fine. The motor/trans didn't go in yet, as I'm awaiting a replacement K-member and oil pan before sliding it all in. Still got a lot to do--Rear, brake lines, fuel lines, body harness and dash--before bringing her over to Jim/Rob for prep/paint.


Definitely looking forward to seeing you up here again, bud. Get home soon!

yeah buddy. I can't wait to be home man, I'm gonna live up by you ahaha. You should come by my place sometime when I get home and examine my parts cache to see if anything else in there that u can use.

I'm actually going to be down in Piscataway either tonight or some time this week--Dropping some stuff off at BLS Headquarters.

well that doesn't exactly workout since I'm currently in bumfuck, pa. Do you know of it?

Your rooming with nick the stalker? ;)

What a gay thread.

Your rooming with nick the stalker? ;)

I live in bumblef*ck not bumf*ck ;)

Good thing he posted this on 'Tech & not NJFBOA!







...Oh