Engine hoist plate thoughts, please.
#1
Staging Lane
Thread Starter
iTrader: (3)
Join Date: Apr 2010
Location: Vegas
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
Engine hoist plate thoughts, please.
I made this hoist plate today out of 1/4". It's bolted to six of the valley cover holes. I would guess the bare block weighs 80-90lbs and the trans probably weighs about the same. My question is, is it safe to bolt to these holes and move the engine and trans in and out a few times to mock up mounts, steering linkage, oil pan and firewall clearance, etc?