4.190" headgasket okay with a 4.155" bore?
#1
10 Second Club
Thread Starter
iTrader: (27)
Join Date: Nov 2006
Location: Connecticut
Posts: 1,905
Likes: 0
Received 0 Likes
on
0 Posts
4.190" headgasket okay with a 4.155" bore?
I am about to put my engine back together once I get the bearings and gaskets. My initial setup had 4.165" head gaskets on my 4.155" bore block (434ci) and I was told that ill be receiving 4.190" head gaskets this time around. Will I run into any issues running head gaskets this size? The engine will see some nitrous.(150-250 shot)
#4
LS1Tech Premium Sponsor
iTrader: (5)
Yea, no problem. Keep in mind most OEM GM gaskets run a good bit larger than the bore size they are being run on.
__________________
Largest Stocking Distributor of LS-x Engines / CHECK OUT OUR NEW WEBSITE!
COMP - FAST - PACESETTER - DIAMOND RACING - EAGLE SPECIALTY PRODUCTS - CALLIES - COMETIC GASKETS
RAM CLUTCHES - MOSER ENGINEERING - KOOK'S HEADERS - ARP - GM BOLTS AND GASKETS - MSD - NGK
POWERBOND - ASP - AND MORE!
Largest Stocking Distributor of LS-x Engines / CHECK OUT OUR NEW WEBSITE!
COMP - FAST - PACESETTER - DIAMOND RACING - EAGLE SPECIALTY PRODUCTS - CALLIES - COMETIC GASKETS
RAM CLUTCHES - MOSER ENGINEERING - KOOK'S HEADERS - ARP - GM BOLTS AND GASKETS - MSD - NGK
POWERBOND - ASP - AND MORE!
#6
On The Tree
Join Date: Dec 2004
Location: Northville, Michigan
Posts: 124
Likes: 0
Received 0 Likes
on
0 Posts
I am about to put my engine back together once I get the bearings and gaskets. My initial setup had 4.165" head gaskets on my 4.155" bore block (434ci) and I was told that ill be receiving 4.190" head gaskets this time around. Will I run into any issues running head gaskets this size? The engine will see some nitrous.(150-250 shot)
Ask your engine builder what the compressed thickness of your new gasket is compared to your old gasket. This can effect your compression ratio.
Also, where is your piston deck when the engine is cold? Is it above the block, equal to the block, or below the block?
-