General Maintenance & Repairs - Engine stalling

Alright so this recently started happening after I went through an automatic carwash. At first it was just a bogging right afterwords, thought something was happening, downshifted the car and it stopped so I thought I solved it. Then it started getting worse. Was running badly and I stopped at a light and my car was downhill, car stalls out. Try and crank it again, and it needed a little gas to start it. Pulled over on a flat surface and it ran normal. Stalled out again later on a downhill incline.

So I finally got it home, thought it might be the fuel filter pulled it, and it had a terrible flow, so I replaced it with a new one. Started it up, ran fine. Then started driving it around again and ran good for approximately 2 minutes and then it started acting up again. Now it's sitting at my house.

When I turn the key to the on position, I do hear the fuel pump engage. Recent work I've had is a complete engine rebuild (rods/bearings/crank), and I had my tranny rebuilt (4l60e).

Some other things I noticed is the fuel pressure has been a tad lower and my oil does need to be changed. The motor was shaking but it stops.

Video (please ignore me): http://www.youtube.com/watch?v=41B10AQZIbE

Some info on the car:

1998 Chevy Camaro Z28 LS1
87k miles
Auto transmission
Bone stock except for a cutout after my cats on my Y pipe

Any other questions just ask. Thank you!

I think the car wash killed your opti, especially if you got an underbody wash. :p

It's a LS1?

Lookin for ideas.

Here is a vid

http://www.youtube.com/watch?feature=player_embedded&v=41B10AQZIbE

It's a LS1?

And that's why you always include info in your first post or sig...

Updated so I got real info. Finally had a good minute to think and write things down.