View Full Version : shortening torque tube


txcarbuilder
06-21-2012, 10:28 PM
I am going to be building a custom car on a C5 Corvette chassis and the engine will be set back in the frame from the stock location. Has anyone here ever shortened the torque tube and drive shaft on one of these cars? I seem to remember reading that the aluminum that the torque tube is made of is not easily welded and requires special techniques to do so. I would appreciate any information that anyone can give me. Thanks

El_Diablo
06-24-2012, 03:27 PM
Call East Coast Supercharging and talk to them. I'm not sure if they do it in-house or if they have someone do it for them.

txcarbuilder
06-26-2012, 02:30 PM
Thanks, I will check that out.

DBN
06-26-2012, 02:48 PM
RPM Transmissions does this as well. 1-800-406-1109.

txcarbuilder
06-27-2012, 04:59 PM
Thanks,