Removing intake manifold
#1
Launching!
Thread Starter
Join Date: May 2012
Location: Mayfield, KY
Posts: 232
Likes: 0
Received 0 Likes
on
0 Posts
Removing intake manifold
I've been working on and off today taking everything off my caamaro to change the head gaskets and now I've come to the intake manifold. I took out all 5 bolts on each side of it. But it's still not wanting to come out. Are there anymore bolts that I'm missing, maybe behind the intake that I also have to take off? Or is it just hard to take off because the gasket is so old?
#2
TECH Senior Member
iTrader: (2)
I've been working on and off today taking everything off my caamaro to change the head gaskets and now I've come to the intake manifold. I took out all 5 bolts on each side of it. But it's still not wanting to come out. Are there anymore bolts that I'm missing, maybe behind the intake that I also have to take off? Or is it just hard to take off because the gasket is so old?
Once the bolts are out there is a location on the front where you can pry to safely separate the manifold from the block.
#3
Launching!
Thread Starter
Join Date: May 2012
Location: Mayfield, KY
Posts: 232
Likes: 0
Received 0 Likes
on
0 Posts
I found them lol. I had actually taken 11 off and just didn't notice until I counted them. I got the intake off now. Also found my ticking problem which was an extremely loose rocker. But I'm gonna take a pic real fast and show you guy how bad and milky this motor is