Generation IV External Engine - cutting my formula to fit bigger mufflers

i HAVE to make this car reasonably quiet, but i'm not giving up my X-pipe setup. so i'm cutting out the sides of the rear compartment area (where the T-tops go) to fit magnaflow offset/center 5x8x14's.

so the full exhaust will consist of long tubes, magnaflow cats, 3" x-pipe, dynomax bullets in front of the axle, magnaflows in the back, and borla 4.5" defuser tips.

i've never seen anyone do this, but i'm expecting it to sound very good.

stay tuned.

I had a thread started about something similar. I wanted to cut the rear passengers seat area out and replace it with a flat piece to fit better mufflers...never got much of a response.