Ls3 FD

720hp
695tq

For around 20k to 24k you can get a complete motor ready to drop in with forged internals. what do you think it would cost you to build this motor yourself? They are built to order!!

I dont know myself but wouldn't mind a few of your thoughts on this topic!

http://www.edelbrock.com/automotive_...niversal.shtml

helga203

If your using your own engine less then half easy. If not around half or little more.I built my 6.0L forged LPE elberbrock racing heads for under 8K.

Ls3 FD

418ci? forged crank shaft, rods, pistons? pump gas 720hp with warranty?

rotary1307cc

iTrader: (5)

Ripoff

helga203

I built myself. It sounds like you want someone to built one for you???? Cubes don't matter when your setting up your own built. Yes i have forged everything i did my setup for s/c'ed i have over 1200whp. I built my motor in 2004 i have over 40k with 0 problems. Non s/c'ed i'm low 500ish that's because how i set it up. lower compression small cam. i just looked at link again rip off.
Well if you got the money buy it. There's a sucker born every minute. Hahahahahahaha

Ls3 FD

Not going to buy it.. I just saw this item and wanted everyones input. I am just doing a bolt on ls3..