600Z build
11-14-2012, 01:51 PM
#1
Teching In
Thread Starter
Join Date: Jul 2011
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
600Z build I thought I'd share this, now that it's finally running. I have done a lot of reading on this forum and had some help from the ls1tech community so thanks for any input you may have given. I still have a few small bugs to shake out but nothing big. Then off to the dyno.
http://ls2.com/forums/showthread.php?p=15097226
Cheers!
http://ls2.com/forums/showthread.php?p=15097226
Cheers!
11-15-2012, 06:28 PM
#4
Teching In
Thread Starter
Join Date: Jul 2011
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
I've already started changing the intake. My IAT was hitting over 120*F just breaking in the engine in the driveway. NO good! I installed a small make-shift card board heat shield just for the time being and it dropped them about 20*F. With the cold air intake I'm hoping for very near ambient.
