Do I have the right pushrod length?
#1
STF Veteran
Thread Starter
Join Date: Jul 2002
Location: Beamville, VA
Posts: 784
Likes: 0
Received 0 Likes
on
0 Posts
Do I have the right pushrod length?
Getting ready to install TEA 5.3 1.5x heads milled .010 with a CC224/563/112. The trick flow rods sent from TEA are 7.4's. I want to make sure the preload is right as I do not want to go back in to correct anything. Hopefully with all the boltons, ported TB, FLP's, 4.10's, etc, I'll be celebrating mid to low 11's. Thanks fellas.