Boryke

The switches

Nitrous Arm - Purge - Bottle Heater
Linelock - Two Step


Why? Because race car.

BarneyMobile

iTrader: (4)

I'd try to hide the wires to the micro edge.

Boryke

I've been thinking of a way to do this.... any suggestions?

jblankenship

iTrader: (5)

just drill a hole threw the panel and use a gromet. If you have to cut the wires put them on a plug so you can remove it with the whole panel if needed.

green94z

iTrader: (6)

Agreed with above, grommet and hole

krissoto

iTrader: (3)

If you can move the microedge all the way to the left side and cut out a section for the wires. Very nice set up though.

onefast84

Tuck those wires, and will look great! I gots to get me one of those controllers!

djfury05

iTrader: (30)

Agreed. You can make the hole very small that way almost unnoticeable.

Blackpanther99

iTrader: (8)

Looks good just hide the wires as everyone has been posting. Lol

greenvortec97

iTrader: (1)

forget the wires, where's the Stereo at? race car or not it should have some jams

Blackpanther99

iTrader: (8)

I think some little speakers from Walmart with a IPOD usb port will do good.

GiggleJuiced_SS

iTrader: (31)

what material did u use for this. nice job btw. ive been thinking of modifying my nitrous outlet panel to put my line lock switch in there instead of the remote opener.

krissoto

iTrader: (3)

piece of abs plastic is what mine is constructed out of, looks like the same material.

Beer99C5

iTrader: (21)

ZackMorris

Beer- pics of your panel mounted in a car?

Beer99C5

iTrader: (21)

Not my Panel, I Made that for a member. I do not have a F Body. was showing how to hide the wiring.

Juicedh22

iTrader: (6)

Beer, how/where do you do the letters/words on the panel? I hunted forever trying to find a vinyl shop who could print letters small enough...

Beer99C5

iTrader: (21)

I own a Laser engraver

onefast84

Nice! What kind of prastic is that, and where can I find some?

Beer99C5

iTrader: (21)

Rowmark is the manufacture, I use textured mostly but some peeps like smooth. Google Rowmark and you can see who distributes near you. Most sign shops or laser engraver shops (Trophy shops) can get it for you. I recommend using 1/8" vice 1/16" as the thinner material is flimsy.