87__TA

Category: Drivetrain
Price: $3000
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette
Location (State): PA
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LT1/LT4, Small Block, Big Block
LS Engine?: Non-LS Part

Guaging interest here: Have Complete Faceplated T56 from liberty, Custom input shaft with 2.78 1st gear set, billet input tube support, 31 spline Viper/727 output shaft.. Works great but 5th gear syncro is going bad - still goes in but like a little clutch to do so.
I have gone 9.3 with this trans..

-In adddition I have included PST Aluminum driveshaft with Chromoly Viper coversion spline shft and all 1350 joints front and rear. $550 VALUE new
-Centerforce 36lb flywheel to fit LT1 style 11" clutch for 2pc rear seal SBC.
-Spec 3 clutch/Pressure Plate with over half life.. Though these are rated for 600 or so HP.. It's my thrid one over the years throwing much more to it and it performs great for me - good street manners. $550 value ish. new
-Tick Performance Adjustable clutch master with new slave. $400 I think it was.
-McLoad Bellhousing/scatter shield. Also included are offset dowel pins for perfect alignment.. $400 ish value. It has been clearanced in areas for headers/ect..
- Pro 5.0 shifter, LS/T56 Upper console with boot..

I would say collectively this is worth much more as I have over 2500 in trans alone.

Here is a video of car.

Mikey 97Z M6

iTrader: (37)

Props for getting it done with the 6sp!! Badass video and a free bump for ya.

Mike