Yet another question about Weld RTS
05-15-2013, 03:58 PM
#1
On The Tree
Thread Starter
Join Date: Aug 2006
Location: Raleigh, NC
Posts: 135
Likes: 0
Received 0 Likes
on
0 Posts
Yet another question about Weld RTS Getting ready to pull the trigger in the coming days on some black Weld RTS. Trying to make sure that I'm not missing anything when I finally get ready to slap them on.
Fronts
15x4 w/ SRs (26/6/15)
Rears
15x10 w/ 28" MT ET St. (275/60/15)
Car is stock ride height for now (will be adding QA1s when I recover from this LOL). I understand that I may have to roll my fender with it being a 28" tire and may have to bang in the wheel well slightly.
I've read a couple of posts about people having the fronts rub but it seems that isn't usually the case, right? I've looked at so many wheel/tire options here lately that it is starting to run together.
Am I missing anything? Anyone have a picture of this setup on stock springs/shocks? I've found a ton of pictures of these wheels but I don't know if any of them are at stock ride height.
Thanks in advance!
Fronts
15x4 w/ SRs (26/6/15)
Rears
15x10 w/ 28" MT ET St. (275/60/15)
Car is stock ride height for now (will be adding QA1s when I recover from this LOL). I understand that I may have to roll my fender with it being a 28" tire and may have to bang in the wheel well slightly.
I've read a couple of posts about people having the fronts rub but it seems that isn't usually the case, right? I've looked at so many wheel/tire options here lately that it is starting to run together.
Am I missing anything? Anyone have a picture of this setup on stock springs/shocks? I've found a ton of pictures of these wheels but I don't know if any of them are at stock ride height.
Thanks in advance!
