Done.........for now
#1
10 Second Club
Thread Starter
iTrader: (4)
Join Date: Dec 2012
Location: Winchester, VA
Posts: 350
Likes: 0
Received 0 Likes
on
0 Posts
Done.........for now
I've been busy since around thanksgiving. I recently painted my 99 tran am and a handful of performance mods. In that time cleaning the ol girl has not been a priority, until I felt froggy this evening after work.
Appearance wise
Full color change to hot rod black (I have dubbed it **** it black. No wax, no buffing and I can touch up rock chips with a sharpie)
Gunmetal 30th anny stripes
Performance
Strange S60 with Detroit locker 35 spline axels 4.10 gears
Strange SA coil overs up front
Fast 92 home ported
Nick williams 92 tb
Founders adj control arms
275/60/15 Mickey Thompson et streets
Awaiting install
Bmr k member upper and lower a arms
Kirkey seats
6pt roll bar
Still dialing in ride height in the front. Also leaving a fair amount of power on the table so I'm trying to get it on the dyno by the end of June.
If it'll work a little idle clip through the cut out. Excuse the fact that apparently I'm a dumbass and covered the mic on my cellphone
Appearance wise
Full color change to hot rod black (I have dubbed it **** it black. No wax, no buffing and I can touch up rock chips with a sharpie)
Gunmetal 30th anny stripes
Performance
Strange S60 with Detroit locker 35 spline axels 4.10 gears
Strange SA coil overs up front
Fast 92 home ported
Nick williams 92 tb
Founders adj control arms
275/60/15 Mickey Thompson et streets
Awaiting install
Bmr k member upper and lower a arms
Kirkey seats
6pt roll bar
Still dialing in ride height in the front. Also leaving a fair amount of power on the table so I'm trying to get it on the dyno by the end of June.
If it'll work a little idle clip through the cut out. Excuse the fact that apparently I'm a dumbass and covered the mic on my cellphone
#3
10 Second Club
Thread Starter
iTrader: (4)
Join Date: Dec 2012
Location: Winchester, VA
Posts: 350
Likes: 0
Received 0 Likes
on
0 Posts
The mods in my sig. The stuff I put up was just what I've done this winter. The car has most of the bolt ons a set of lightly ported 241 heads and the Texas speed 224r cam on a 112 lsa