04-30-2004, 12:23 PM
I was gonna put my shift light in the AC vent,but I think I might like it better in the A-pillar.What is the best route to wire it without the wire being seen.Also what all is needed to take off to get it in there?
05-01-2004, 10:10 AM
The A-Pillar just has some clips that hold it in place, carefully pull it off. See that window defrost vent (the circle) on it? Cut out those little grille spokes and it will fit in that location.
If your car is a T-Top car, I think there might be two screws at the top. I can't remember, mine is a convertible.
05-01-2004, 10:30 AM
I'm gonna put my raptor light in the AC vent. Seems like a lot less hassle.
yea, there is a screw there up top if u rem...not positive, u can run the ground along the a pillar to one of the screws, my power line is connected to my lights, so i can turn it on and off, then ran the pcm line down the front of the car, up behind the pedals, out of view, behind the radio, and through the firewall