Advice on PCV setup with Holley valve covers abd Edelbrock intake
09-09-2013, 11:09 AM
#1
Teching In
Thread Starter
iTrader: (1)
Join Date: May 2006
Location: Winnipeg,Canada
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Advice on PCV setup with Holley valve covers abd Edelbrock intake When I bought my car it had stock valve covers with a filter on the oil fill hole on the passenger cover. The PCV on the drivers cover was tied to the passenger cover by a rubber hose.
I just put Holley valve covers on that have a spigot on each valve cover. I can't see any place on the Edelbrock in front of the throttle blade to tie into. I can tie into the SLP lid if I put a spigot on. I also can't find a plug on the Edelbrock manifold as a source of vacuum to run a PCV.
Should I tie the passenger cover to the fresh air side on the lid and try to find a vacuum source with a PCV for the driver cover?
Thanks.
I just put Holley valve covers on that have a spigot on each valve cover. I can't see any place on the Edelbrock in front of the throttle blade to tie into. I can tie into the SLP lid if I put a spigot on. I also can't find a plug on the Edelbrock manifold as a source of vacuum to run a PCV.
Should I tie the passenger cover to the fresh air side on the lid and try to find a vacuum source with a PCV for the driver cover?
Thanks.
