Fully Rebuilt, Machined, and Milled L92 Heads Ready to run
09-22-2013, 05:36 PM
#1
Teching In
Thread Starter
iTrader: (3)
Join Date: Oct 2006
Location: Lakewood, Co
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
Fully Rebuilt, Machined, and Milled L92 Heads Ready to run Category: Engine - Intake/Fuel
Price: $650
Part Fits: 2010+ Camaro, Corvette
Location (State): TX
Item Condition: Brand New
Shipping Information: Item Can be Shipped
LS Engine?: Fits LS Engine
I have a set of newly rebuilt and Milled L92 Heads, casting number 5364 that have been completely cleaned, Glass beaded on the intake and exhaust ports, had a serdi valve job performed, and new viton rubber seals installed with stock valvesprings re-installed.
The rocker arms aren't pictured, but are included.
The heads have been milled .020, so the CC's have been reduced approximately 3.5 cc's less than stock, adding about .4:1 to the compression ratio.
These heads had approximately 65,000 miles on them before being refurbished.
Last edited by WRXINTX; 10-01-2013 at 06:08 PM.
