Dual Walbro fuel setup w/ Hotwire & etc.

09-26-2013, 09:21 PM

#1

djfury05

10 Second Club

Thread Starter

iTrader: (30)

Join Date: Jan 2008

Location: Beaufort, SC

Posts: 3,430

Likes: 0

Received 3 Likes on 2 Posts

Dual Walbro fuel setup w/ Hotwire & etc.

Category: Engine - Intake/Fuel
Price: $175
Part Fits: 2010+ Camaro, 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette, 04-06 Pontiac GTO, 04+ Cadillac CTS-V, 67-92 Chevrolet Camaro, 67-92 Pontiac Firebird
Location (State): SC
Item Condition: Brand New
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine

I've got a dual Walbro fuel pump setup with sending unit for sale and a homemade hot wire kit is also available for 1 of the pumps. The pumps have never had any fuel ran through them but the filters have been submerged into the tank with gas for a test fit and then the setup was removed. The pumps are brand new Walbro 255 pumps. Included with the setup but not installed is a metal "Y" fitting to take the place of the shitty plastic "Y" that breaks over time. The metal "Y" fitting was $30 ALONE.

The bucket has already been modified for the use of an aftermarket pump which requires holes on the bottom or sides since the venturi function is removed.

FYI you will need to splice in the floater wiring to the bulkhead connector. Its 2 wires.

I will also be including a bag with extra assorted stuff that I received with my dual pump setup but did not use. There will be an extra Walbro 255 pump as well but it has been used and is still good I just opted for new pumps.

I am looking to get $175 plus shipping for the dual fuel pump setup without the hot wire kit. If you want the hot wire kit add $15. New Walbro 255 pumps are around $80-90 bucks alone, this is a complete kit with sending unit and upgraded $30 metal "Y" fitting ready to go.

Last edited by djfury05; 09-27-2013 at 09:21 AM.