OVA1

iTrader: (12)

The subframe of the Unibody at the front mount of the LCA on both sides bent… due to the floor pan being roached. Cut out a fair bit, but it's looking like it's going to be a job and I don't know jack about this stuff.

So I'm coming to the mountain…

Men of the Body section: WTF? Any ideas?

Uneverknow

iTrader: (1)

You have any pics?

Randolph Ziskey

iTrader: (13)

^^^^^^

OVA1

iTrader: (12)

I will take some and post them up today.

OVA1

iTrader: (12)

The Driver side is about the same, not bent quite as bad.

OVA1

iTrader: (12)

Anyone got any experience in this mess?

chrysler kid

iTrader: (14)

That car is all sorts of rusted. Abandon the chassis and transfer parts to a newer roller and cut your losses. The rear seats section is almost rusted out too.

If you have to save it I would just cut the floor pans out of a donor car

OVA1

iTrader: (12)

Oh man… That blows.

But thanks for the advice. Can't say I disagree, I was just hoping someone had seen it and fixed it.