LXinMS

iTrader: (58)

I'm looking at an L92 that needs a sleeve, lifter issue, dropped valve, the usual. I'm getting it for a steal, so I have a little wiggle room, thinking about a full sleeve job, not just the affected cylinder. Current machinist said he could do a single sleeve, but the cylinders around it would get out of round a bit.

slow67

iTrader: (2)

Give Grice's machine shop in Durant, OK a call.

98noscamaross

iTrader: (2)

Agree with slow67, grice does a good job and hes very reasonable on his prices. He does all the roundy round guys around here.

boostnificent

iTrader: (7)

Kustom Machine in Denison, TX can get it done for you as we'll.

01Z0H6

iTrader: (63)

Kim Barr if you want to drive down to Garland.... Pricey! But will be done right the first time.