Sikfricks

i have a full int 95 z28 it has a stock cube lt1. it has a hughes th350 that was built for a bbc (real short 1st) 373rear. forged scat crank, scat h beams, mahley forged pistons, heavily ported w2 heads, cc306 with 1.7 rockers. all the bolt on ported manifold 58mm tb etc tuned on 93 what have you guys seen previous setups run on motor only

96lt1m6

iTrader: (31)

Similar motor, Hooker longtubes,4L60e,3600 stall,4.10s and ET streets 26x10 ran 11.4 at sea level.
You really need 4.10s

Sikfricks

Forgot to post my stall 8 inch 3600 real tight I believe I diff need to gear it

Sikfricks

Do you have any 1/8 mile times

96capricemgr

iTrader: (1)

What are "w2" heads?

A WELL setup heads/cam LT1 f-body can run low 11s in the quarter low 7s in the 8th. thinking you are going to be a second slower.

Sikfricks

Factory lt1 heads larger valves heavily ported the car is very quick on the street pulls hard just wanting to run a 235 class trying to get a baseline and add nitrous from there

SS RRR

iTrader: (2)

3/4 race cam?

Sikfricks

Little bigger than 3/4 lol

SS RRR

iTrader: (2)

Full ******' race cams?