SRVDean

I've looked for a while and I've seen some expensive options, and I've seen some really ugly ideas, but here's the question I have.

What is the best end-all intake set up for a 400Hp and under NON WS6 car? I'm running a speed density tune so a MAF is not a concern. Would a lid on the stock bottom piece with a bellow to the throttle body be the best bet? Cutting out the bumps on the front of the hood?

HCI2000SS

iTrader: (2)

A lid with a SSRA or Chris1313. You could also port the TB for really chaep as well

FU_I_AM_UltraZ

iTrader: (20)

speed density tune... then i would just port the TB and run a straight smooth tube to the TB take the top air lid off and use a C5 flat cone air filter (blackwing type setup)

Kingc8r

iTrader: (21)

This.