BLWNLT1_T/A

iTrader: (12)

Longs story short. I have a built 355 that has been sitting for about 6 years covered up of course. All I need to do is install itake, oil pump and oil pan to start install. Should I install or go through everything again? Everything is new in this block no used parts all still looks nice and shiny.

nomoneyz

iTrader: (15)

Where was it stored at? I've never tried firing an engine after that long but if it was stored properly I don't see why you shouldn't run it.

96lt1m6

iTrader: (31)

I would go for it just be sure to prime that oil pump.

nitrous2fast

iTrader: (2)

check the cylinder walls for rust. if none, put it together and have fun.

LilJayV10

iTrader: (39)

If it has been stored properly I'd put some marvel mystery oil in each of the cylinders and let it sit over night. turn it over by hand several times to ensure everything is free. pressure prime it and let her eat.

BLWNLT1_T/A

iTrader: (12)

Had it stored in a shop covered up on an engine stand. All still looks like the day I covered it up. I flipped it over and everything is still nice and shiny...