Randolph Ziskey

iTrader: (13)

This is the first one they sent..
https://ls1tech.com/forums/manual-tr...ss-member.html
with the help of ls1tech members we determined it was the wrong one...Bob worked on it fast and in a week with the shipping I got another one...this is the one I just recently received.



The holes on the ends line up but the one in the middle of the flat part is a little off. Is there anything that I am doing wrong? Am I supposed to shift the trans to the right a little to make it fit but then I figure the drive shaft will be out of line to the rear. Please help!!!! Any advice is appreciated.

Randolph Ziskey

iTrader: (13)

Sorry for third pic upside down don't know why it did that....

Burken01

iTrader: (88)

That's not the right crossmember at all! The hole for the trans mount bushing should be dead in the middle..

Burken01

iTrader: (88)

Assuming you have a t56 manual you need this one.

http://www.bmrsuspension.com/?page=p...&productid=327

benny92

There should be an offset bracket for the trans mount. Should be included with the t56 kit, probably missing since you received wrong crossmember kit.

Moser Installation Step 20/21

Randolph Ziskey

iTrader: (13)

Thanks for the info. I will check the packaging after work. I am hoping I missed it. Been a good learning experience. Been patient but sucks when you can only work on it on the weekend after work until sun goes down. Thanks again guys.

Bob@BruteSpeed

iTrader: (16)

Did you get my e-mail? Let me know if you have the adapter. Thanks. Bob

Randolph Ziskey

iTrader: (13)

Hey Bob emailed you back and I found it under the padding...I misspelled padding in the email..thanks for responding...