titanium valves, throttle body, ls3 intake, injectors LY6, LQ9 BLOCK
#1
Teching In
Thread Starter
iTrader: (5)
Join Date: Dec 2011
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
titanium valves, throttle body, ls3 intake, injectors LY6, LQ9 BLOCK
Category: Engine - Complete Motors
Price: $1
Part Fits: 2010+ Camaro, 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette, 04-06 Pontiac GTO, 04+ Cadillac CTS-V
Location (State): NY
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine
I have a nice bare iron newer style LY6 6.0L block. I bought this block with only 1,200 miles on it with the intentions of building a stroker and health problems have changed my plans. This block is in good shape still standard 4.00" bore, I had it checked out and it is ready to be machined and built into them engine of your dreams. It is the LY6 version with cam sensor on timing cover and knock sensors are on the pan rails instead of the valley area. The block has been deburred and magnafluxed for cracks and mains have been checked for straightness and size. I also had a couple cylinders sonic tested and it has no core shift and very good cylinder thickness, so I intended on boring this block 4.080" or 4.100" . Block is in heated storage, this is a low mile block ready machine work for your build, may have some light surface rust in cylinders from storage, but it will come right off when machined and washed.
Asking $650 plus shipping, will put on a pallet and ship, buyer pays shipping.
INCLUDES- BLOCK, VALLEY COVER, REAR COVER, HEAD STUDS, 2 NEW MLS 4.070" HEAD GASKETS
INTAKE MANIFOLD
NEW L92 truck intake just as shown, billet fuel rails and braided line and fittings, 50lb injectors with adapters, used 90mm LS7 throttle body, includes map sensor too. $650 shipped, just the injectors cost me $350
VALVES $350 for full set of 8 Intake and 8 exhaust valves OBO
Intake Valves- 8mm Del-West 2.088" titanium intake valves super low miles around 1,100, these have been clean and checked and have a fresh seat angle cut on them with the lash caps installed these match the exhaust length at 5.150" that's LS7 length or +.100" for normal LS1
Exhaust Valves- 8mm Ferrea Super Alloy hollow stem 1.60" these are LS7 length, these have been clean and checked and have a fresh seat angle cut on them.
Last edited by 1bad8118; 02-03-2014 at 05:00 PM. Reason: added parts