Sleeperls

Ordered my swap k member from summit and noticed the design is a little different from most ive seen.

The bottom bar is square.

06Sierra2

That's how mine was as well. I had problems fitting the a arms in and the mounts for the steering rack but it was very minimal clearancing

streetknight2

iTrader: (10)

Could you elaborate a little on the problems?

I just put one in over the weekend and the steering rack if you get one side lined up, the other bushing will not start.

On my A arms, stock ones will slide right in, but my UPR tubular A arms won't start at all, they look way off for some reason.

I have the exact same setup on my other car with no issues, so I know "it should" work. My other car has the older round tube k member though

Sleeperls

The older tube style where better imho.

My a arms are aje and they where tight to go in. I dont have a manual rack yet to try the rest. The tubes that hold the rack slid right in.

onequiklx

mine is square tube and everything went on just great with no problems. used aje a arms and manual rack.

LsoneGT

iTrader: (2)

Mine is square. Zero issues using upr a arms.

usdmholden

Ah-ha, quality control. The reason I did not buy a second AJE after having the first AJE.

The Guy in MY 99TA

yeah im gunna go with team Z stuff. I been reading too much about AJE that I don't like.

06Sierra2

My A arms would not slide in at all. I could get one bushing to fit but not the other side and vice versa. I took a rubber mallet and beat the tabs out a little for the arms to fit. Everything seemed to bend back in place and tightened up the gaps just fine when i tightened the bolts. My manual steering rack didnt fit on one side at all either. I had to take a dremel and slightly modify the hole in the K. Everything tightened up fine but it was annoying and i would probably buy a different K member in the future.

Sleeperls

I would have went team z if i had known the new design worked with the f body pan.

I got the k member in the car today with not much hassle.