how do i get to a 10.7:1 CR?
#1
TECH Fanatic
Thread Starter
how do i get to a 10.7:1 CR?
i believe my chambers are coming out around 68cc in my 5.7 heads.
if i use a stock graphite gaskit how much do i need to mill the heads
to get a 10.75 to 10.8-1 CR....anyone???
or is there a gasket i can use to get that CR ???????
if i use a stock graphite gaskit how much do i need to mill the heads
to get a 10.75 to 10.8-1 CR....anyone???
or is there a gasket i can use to get that CR ???????
Last edited by M6HuggerSS; 05-12-2004 at 11:02 PM.