Wallj

iTrader: (1)

I am in the process of installing a fuel pressure gauge onto my LT1. Ive been trying to remove the schrader valve core but I can't get the damn thing out. I'm using just a regular valve core remover from Autozone, but I can't get the thing to hookup and twist out. Am I doing something wrong??

bowtienut

iTrader: (1)

Lefty loosey. It's no more complicated than that.

leadfoot4

iTrader: (1)

Some of those valve core tools also have a "thread chaser" that sticks out of the tool, 90* to the stem of the tool. If you have one of these, you might have to knock this part out...

96capricemgr

iTrader: (1)

what gauge are you using? Guys have had the long term weight on that fitting crack it from the pipe.

Wallj

iTrader: (1)

I just have a little tool similar to this. Hole in the middle with two prongs.

Wallj

iTrader: (1)

I'll be running braided fuel line from the schrader valve over behind the PCM where I'll mount the sensor then run the wires inside to a pillar pod.