Aaron Thomas

iTrader: (1)

Can anyone confirm that this harmonic balancer is the correct fit for an LS2? Even looking at the chart on the ATI website has me a bit unsure and I don't want to get the wrong item.

http://www.ebay.com/itm/ATI-Super-Damper-LS1-LS2-LS3-LS6-Corvette-G8-04-07-CTS-V-SFI-BLEM-917279-/191122764150?pt=Motors_Car_Truck_Parts_Accessories&hash=item2c7fcdf176&vxp=mtr
If anyone has used this part number with success I'd appreciate the feedback.

bmylez

iTrader: (3)

Also, you're aware that that part is a blemish, right? You have to measure the inner diameter to make sure it's a solid press fit.

InfrareV

I would expect it to work, I'm using 917246 which should be the same p/n only the one you're looking at is aluminum and underdrive.

It's a cosmetic blemish...

garrettg

iTrader: (1)

No ac pulley so keep that in mind.

bmylez

iTrader: (3)

If you read around, you will see that people have bought blems and the inner diameter was too big, slid right onto the crank.

garrettg

iTrader: (1)

ATI is great to work with they sent me a new ac pulley after buying a blem that had a chip on the edge of that pulley which was shredding ac belts. Also my blem hub was a tight fit no issues there.

93hatch

iTrader: (9)

are these cars corvette or f body accessory spacing?

Aaron Thomas

iTrader: (1)

Hmm...not quite willing to give up the a/c in Arizona. Guess it is either man up and pay full price, or wait until the underdrive pulley with a/c comes up with a blemish.

MichaelSuch

I had zero issues with my ATI Blem. 10k miles on it and still spinning true.

bmylez

iTrader: (3)

Yes, I didn't say all blems were bad. There was a rash of out of spec blems on eBay and it doesn't hurt to check the inner diameter before installing.