Intake/TB Swap- Codes and Idle issues
#1
Teching In
Thread Starter
Join Date: Jun 2012
Location: Houston Tx
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Intake/TB Swap- Codes and Idle issues
So I installed my BBK intake manifold and Potz ported ls1 throttle body.
During the whole process I broke and replaced the OPSU and my PCV hoses.
So I replaced those as well.
Also go that ugly EGR out of there and replaced my alternator
Anyways with that being said. I turn the car over and the RPMs jump up to like 500 and immediately die. Next time I gave it a little gas and the rpms sat at 500 for a few seconds and dropped down to 400 and stayed.
The car has a stock cam and normally on a cold start hits 1100 RPMs for a few minutes and levels off at 850.
After some reading on here I cleaned my MAF and my IAC but nothing changed.
The codes the car is throwing are as follows. P0332, P0327, P0506.
Does this seem like something that is tune related or do I possibly have a vacuum leak?
PS The car is an Auto
During the whole process I broke and replaced the OPSU and my PCV hoses.
So I replaced those as well.
Also go that ugly EGR out of there and replaced my alternator
Anyways with that being said. I turn the car over and the RPMs jump up to like 500 and immediately die. Next time I gave it a little gas and the rpms sat at 500 for a few seconds and dropped down to 400 and stayed.
The car has a stock cam and normally on a cold start hits 1100 RPMs for a few minutes and levels off at 850.
After some reading on here I cleaned my MAF and my IAC but nothing changed.
The codes the car is throwing are as follows. P0332, P0327, P0506.
Does this seem like something that is tune related or do I possibly have a vacuum leak?
PS The car is an Auto